《(5.1.1)--5.1StandCollars.pdf》由会员分享，可在线阅读，更多相关《(5.1.1)--5.1StandCollars.pdf（11页珍藏版）》请在taowenge.com淘文阁网|工程机械CAD图纸|机械工程制图|CAD装配图下载|SolidWorks_CaTia_CAD_UG_PROE_设计图分享下载上搜索。
1、Stand Collar Draping For Fashion Design CollarsCONENTS01 Introduction02 Style analysis03 Preparation of the muslin04 Draping the collar1.Introduction collarless Based on the structure of the collar,the collar can be categorized into three types:1.Introduction collarless Closed collar Open collar Bas
2、ed on the structure of the collar,the collar can be categorized into three types:collarless：the neckline is the collar style line Closed collar：the first collar button is closed,e.g.the stand collar and the flat collar Open collar：Notched collar,the lapel,cut in one piece with the front of the garme
3、nt,the collar cut separately,the part below the neck is open e.g.the tailored collar,the shawl collar1.Introduction The stand collar is a raised band up from the neckliner.By adjusting the stand width and the neckline ease,there can be many variations.Stand collar can also be called as Mandarin Coll
4、ar,provides a neat and tailored finish,the two sides of the collar can be round or straight,meeting at center front,sometimes they may be spaced apart,or overlap for closing.2.Style analysis01 Length of muslin:1/2 neckline+10 cm Width of muslin:collar width+5cm02 Draw a grain line for the CB line 2.
5、5 cm from the left edge.Draw another grain line 1.3 cm from the lower edge of muslin.3.Preparation of the muslin01 Pin the intersection of the center back and the 1.3cm line to the back neck point,pin the center back line.02 smooth the muslin along the back neckline,clipping into the 1.3cm extension
6、 at the neckline,maintaining ease at the upper edgeNote:keep the straight grain at the neckline for approximately 4 cm.4.Draping the collar 03 Continue smoothing the muslin along the back neckline,clipping into the 1.3cm extension at the neckline,maintaining ease at the upper edge until the center f
7、ront is reached,pin the neckline,the grain will have dropped approximately 1.3cm at the center front04 Mark the neckline edge line,mark the side neck point,shape and draw the height and the style of the collar4.Draping the collar 05 Take off the collar from the dress form,connect the neckline and th
8、e upper edge of collar,shape the front of collar as desired,add seam allowance,trim away the excess muslin.4.Draping the collar 06 Fold the seam allowance above the upper edge of collar,pin the collar back on the dress form,check if the upper edge of collar is round and smooth,and if the ease is distributed evenly.Check fit and make correction.4.Draping the collar