《(完整版)螺栓检测报告.doc》由会员分享，可在线阅读，更多相关《(完整版)螺栓检测报告.doc（3页珍藏版）》请在taowenge.com淘文阁网|工程机械CAD图纸|机械工程制图|CAD装配图下载|SolidWorks_CaTia_CAD_UG_PROE_设计图分享下载上搜索。
1、螺栓检测报告（一）INSPECTION REPORT OF BOLTS螺栓化学成份Chemical Composition of Bolts化学成份 ChemicalCompositionC%Si%Mn%Ti%Cr%B%P%S%Cu%标准值（Standard Value）40 Cr0.37-0.440.17-0.370.50-0.800.80-1.100.0350.03520Mn TiB0.17-0.240.17-0.371.3-1.60.04-0.1 0.0005- 0.003535CrMoA0.32-0.400.17-0.370.40-0.70.80-1.100.0350.0350.15-
2、0.2535VB0.31-0.370.17-0.370.50-0.900.0010.0040.040.040.25实测值（Actual Value）试件抗拉力试验Tensile Testing of Specimens机械性能MechanicalPerformance 抗拉强度b Mpa Tensile Strength屈服强度0.2 MpaYield Strength伸长率5 Elongation Rate收缩率% Shrinkage rate标准值 Standard Value1040-12409401042实测值（Actual Value）螺栓楔负载试验Load Test of Bolt
3、 Wedge规格SpecificationM16M20M22M24M27M30标准值KN Standard Value163-195255-304315-376376-438477-569583-696试件号ModelofTestSpecimen12345678实测值（Actual Value）当螺栓L/d3,不能做楔负载试验，以芯部硬度试验代替Substiute strength test of core for load test of bolt wedges when bolt wedges L/d3螺栓检测报告（二）INSPECTION REPORT OF BOLTSJ螺栓芯部硬度试验
4、Hardness Test of Bolts标准值（Standard Value）HRC33-39试件号ModelofTest Specimen12345678实测值（HRC）Actual Value垫圈检测报告INSPECTION REPORT OF WASHER垫圈化学成份Chemical Compisition of Washer钢号45#Stell gradeC%Si%Mn%P%S%标准值Standard Value0.42-0.500.17-0.370.50-0.800.040.04实测值（Actual Value）垫圈硬度试验Hardness Test of Whashers标准值
5、Standard ValueHRC 3545试件号ModelofTest Specimen112345678实测值（HRC）Actual Value螺母检测报告（三）INSPECTION REPORT OF BOLTS螺母化学成份Chemical Composition of Nuts化学成份Chemical CompositionC%Si%Mn%V%B%P%S%标准值（Standard Value）350.32-0.400.17-0.370.50-0.800.040.04450.42-0.500.17-0.370.50-0.800.040.0415Mn VB0.12-0.180.17-0.3
6、71.2-1.60.07-0.120.0005-0.00350.040.04实测值Actual Value试件Specimen螺母保证载荷试验Warranty Load Test of Nuts规格SpecificationM16M20M22M24M27M30标准值Standard Value163255315367477583试件号ModelofTestSpecimen12345678实测值(HRC)Actual Value合格Qualified合格Qualified合格Qualified合格Qualified合格Qualified合格Qualified合格Qualified合格Qualif
7、ied螺母硬度试验Hardness Test of Nuts标准值Standard ValueHRC 24HRC 32试件号Model of TestSpecimen112345678实测值（HRC）Actual Value连接副扭矩系数检测报告COEFFICIENT OF TORQUE INSPECTION REPORT OF SETS连接副扭矩系数试验 Coefficient of Torque Test of Sets平均标准值The Average Standard Valre0.1100.150试件号Model of Test Specimen112345678实测值 Actual Value实测值平均值 The Average Actual Value测试环境温度CTestambient temperatureC标准偏差Standard Deviation相对湿度度%Opposite wet degree%标准值Standard Value实测值 Actual Value