《通信协议一致性测试.doc》由会员分享，可在线阅读，更多相关《通信协议一致性测试.doc（63页珍藏版）》请在taowenge.com淘文阁网|工程机械CAD图纸|机械工程制图|CAD装配图下载|SolidWorks_CaTia_CAD_UG_PROE_设计图分享下载上搜索。
1、3GPP TS 34.123-1 V9.2.0 (2010-09)Technical Specification3rd Generation Partnership Project;Technical Specification Group Radio Access Network;User Equipment (UE) conformance specification;Part 1: Protocol conformance specification(Release 9)The present document has been developed within the 3rd Gene
2、ration Partnership Project (3GPP TM) and may be further elaborated for the purposes of 3GPP.The present document has not been subject to any approval process by the 3GPP Organizational Partners and shall not be implemented.This Specification is provided for future development work within 3GPP only.
3、The Organizational Partners accept no liability for any use of this Specification.Specifications and reports for implementation of the 3GPP TM system should be obtained via the 3GPP Organizational Partners Publications Offices.Keywordsmobile, MS, terminal, testing, UMTS3GPPPostal address3GPP support
4、 office address650 Route des Lucioles - Sophia AntipolisValbonne - FRANCETel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16Internethttp:/www.3gpp.orgCopyright NotificationNo part may be reproduced except as authorized by written permission.The copyright and the foregoing restriction extend to reproducti
5、on in all media. 2010, 3GPP Organizational Partners (ARIB, ATIS, CCSA, ETSI, TTA, TTC).All rights reserved.Change the copyright date above as necessary.UMTS is a Trade Mark of ETSI registered for the benefit of its members3GPP is a Trade Mark of ETSI registered for the benefit of its Members and of
6、the 3GPP Organizational PartnersLTE is a Trade Mark of ETSI currently being registered for the benefit of its Members and of the 3GPP Organizational PartnersGSM and the GSM logo are registered and owned by the GSM AssociationContentsForeword64Introduction641Scope652References663Definitions and abbre
7、viations693.1Definitions693.2Abbreviations694Overview694.1Test Methodology694.1.1Testing of optional functions and procedures694.1.2Test interfaces and facilities694.2Implicit Testing695Reference Conditions695.1Generic setup procedures696Idle mode operations706.1In a pure 3G environment756.1.1PLMN s
8、election756.1.1.1PLMN selection of RPLMN, HPLMN, UPLMN and OPLMN; Manual mode756.1.1.2PLMN selection of Other PLMN / access technology combinations; Manual mode786.1.1.3PLMN selection; independence of RF level and preferred PLMN; Manual mode806.1.1.4PLMN selection of RPLMN, HPLMN, UPLMN and OPLMN; A
9、utomatic mode836.1.1.5PLMN selection of Other PLMN / access technology combinations; Automatic mode856.1.1.6Void876.1.1.7Cell reselection of ePLMN in manual mode876.1.1.8PLMN selection in shared network environment, Automatic mode896.1.1.9PLMN selection in shared network environment, Manual Mode926.
10、1.1.10Presentation of additional information during PLMN selection; Manual mode956.1.1.11Void986.1.1.12Displaying EHPLMNs in manual mode986.1.1.13PLMN selection of RPLMN or (E)HPLMN; Automatic mode1016.1.1.14Network selection mode at switch-on1046.1.1.15Exception in manual network selection mode whe
11、n HPLMN is available at power-on1076.1.2Cell selection and reselection1116.1.2.1Cell reselection1116.1.2.1aCell reselection for inter-band operation1146.1.2.1bCell reselection for inter-band operation(LCR TDD band a-f)1146.1.2.2Cell reselection using Qhyst, Qoffset and Treselection1156.1.2.3HCS Cell
12、 reselection1196.1.2.4HCS Cell reselection using reselection timing parameters for the H criterion1216.1.2.5HCS Cell reselection using reselection timing parameters for the R criterion1246.1.2.6Emergency calls1276.1.2.7Void1296.1.2.8Cell reselection: Equivalent PLMN1296.1.2.9Void1336.1.2.9aCell rese
13、lection using cell status and cell reservations Type “A” USIM1336.1.2.9bCell reselection using cell status and cell reservations Type “B” USIM1356.1.2.10HCS inter-frequency cell reselection1376.1.2.10aHCS inter-frequency cell reselection for inter-band operation1396.1.2.11Cell reselection in shared
14、network environment1396.1.3MBSFN Cluster selection and reselection1436.1.3.1MBSFN only service recognition1436.1.3.2Suitable PLMN selection; MBSFN Frequency List present (unicast carrier)1476.1.3.3Suitable PLMN search; MBSFN Frequency List not present (unicast carrier)1536.1.3.4Cell reservations and
15、 access restrictions; Normal access class only1596.1.3.5Cell reservations and access restrictions; Operator access class1656.1.3.6Cell reservations and access restrictions; Home country services access class1726.1.3.7Inter frequency neighbour reselection / Service activation1746.1.3.8Inter frequency
16、 neighbour reselection / Activation of higher priority service1786.2Multi-mode environment (2G/3G case)1826.2.1PLMN and RAT selection1826.2.1.1Selection of the correct PLMN and associated RAT1826.2.1.2Selection of RAT for HPLMN; Manual mode1846.2.1.3Selection of RAT for UPLMN; Manual mode1906.2.1.4S
17、election of RAT for OPLMN; Manual mode1926.2.1.5Selection of Other PLMN / access technology combinations; Manual mode1946.2.1.6Selection of RAT for HPLMN; Automatic mode1976.2.1.7Selection of RAT for UPLMN; Automatic mode1996.2.1.8Selection of RAT for OPLMN; Automatic mode2016.2.1.8aSelection of RAT
18、 for OPLMN; Different ITU regions2036.2.1.9Selection of Other PLMN / access technology combinations; Automatic mode2136.2.1.10Selection of PLMN and RAT in shared network environment, Automatic mode2156.2.1.11Selection of PLMN and RAT in shared network environment, Manual Mode2186.2.2Cell selection a
19、nd reselection2226.2.2.1Cell reselection if cell becomes barred or S0; UTRAN to GSM2226.2.2.1aCell reselection if cell becomes barred or S0; UTRAN(1.28Mcps TDD) to GSM2246.2.2.2Cell reselection if cell becomes barred or C10; GSM to UTRAN2276.2.2.2aCell reselection if cell becomes barred or C115127.1
20、.6.3.4Impact on E-TFCI selection on MAC at UE for UL DRX at Node B/ MAC Inactivity Threshold =15147.1.6.3.5MAC-es/e transport block size selection(1.28Mcps TDD)5167.1.6.4MAC-es/e - E-DCH retransmissions5207.1.6.4.1MAC-es/e process handling5207.1.6.4.2MAC-es/e maximum number of retransmissions5237.1.
21、6.4.3MAC-es/e Correct handling of MAC-es/e reset5267.1.6aE-DCH MAC-es/e for 3.84 and 7.68Mcps TDD5287.1.6a.1MAC-es/e multiplexing5287.1.6a.1.1MAC-es/e multiplexing without RRC restrictions5287.1.6a.1.2MAC-es/e multiplexing with RRC restrictions5307.1.6a.1.3Correct settings of MAC-es/e header fields5
22、327.1.6a.2MAC-es/e Scheduling5347.1.6a.2.1Correct settings of MAC-es/e scheduling information5347.1.6a.2.2Correct settings of MAC-es/e scheduling information when scheduling delay timer expires5387.1.6a.2.3MAC-es/e correct handling of scheduled transmissions5407.1.6a.2.4MAC-es/e combined non-schedul
23、ed and scheduled transmissions5427.1.6a.2.5MAC-es/e Correct handling of HARQ profile power offsets5447.1.6a.3MAC-es/e- E-TFC selection5487.1.6a.3.1MAC-es/e E-TFC priority5487.1.6a.3.2MAC-es/e transport block size selection/ UL QPSK5507.1.6a.4MAC-es/e - E-DCH retransmissions4757.1.6a.4.1MAC-es/e proc
24、ess handling4757.1.6a.4.2MAC-es/e maximum number of retransmissions4787.1.7E-DCH MAC-i/is4807.1.7.1MAC-i/is multiplexing (multiple PDUs from different LC in one TTI)4807.1.7.2MAC-i/is segmentation / Correct Usage of Segmentation Status Field4827.1.7.3Correct settings of MAC-i/is header fields4867.1.
25、7.4MAC-is/i transport block size selection/ UL QPSK4907.1.7.5MAC-is/i transport block size selection/ UL 16QAM4997.1.7.6MAC-is/i transport block size selection (1.28Mcps TDD)5067.1.8E-DCH MAC-is/i for RACH procedure5087.1.8.1Release of common E-DCH resource when maximum resource allocation for E-DCH
26、 expires or uplink transmission ends for CCCH transmission5087.1.8.2Activation of HS-DPCCH based on the received SIB5/SIB5bis information5137.1.8.3DTCH/DCCH transmission - implicit common E-DCH resource release without receiving E-AGCH5167.1.8.4DTCH/DCCH transmission explicit common E-DCH resource r
27、elease by E-AGCH5197.1.8.5RACH procedure with both normal AIs and extended AIs (using E-AICH).5227.1.8.6DTCH/DCCH transmission - Implicit release with E-DCH transmission continuation backoff - Timer Based5277.1.8.7Physical Channel Failure for EUL in CELL-FACH during initial access preamble5317.1.8.8
28、Radio Link Failure for Enhanced UL in CELL-FACH with DTCH/DCCH active5337.1.8.9CCCH transmission E-DCH access, the UL transmission within the Scheduling Windows5357.1.8.10DTCH/DCCH transmission with E-RUCCH access for dedicated control signalling or dedicated user data when dedicated E-RNTI is alloc
29、ated5387.2RLC testing5407.2.0General5407.2.0.1Radio bearer setup5407.2.1Transparent mode5407.2.1.1Segmentation and reassembly5407.2.2Unacknowledged mode5407.2.2.1General information for UM tests5407.2.2.2Segmentation and reassembly / Selection of 7 or 15 bit Length Indicators5407.2.2.3Segmentation and reassembly / 7-bit Length Indicators / Padding5427.2.2.4Segmentation and Reassembly / 7-bit Length Indicators / LI = 054